Accu-Turn 1500 Manuel De L'opérateur page 72

72
i-1
Installation Instructions
This appendix describes the installation requirements, This appendix describes the installation requirements,
installation procedures and checks. installation procedures and checks.
i. Installation requirements. i. Installation requirements.
Space requirements. Space requirements.
The drawings show the minimum requirements The drawings show the minimum requirements
from a safety viewpoint. from a safety viewpoint.
Refer to drawing i-1 for space requirements. Refer to drawing i-1 for space requirements.
Each drawing has 2 sets of dimensions:
The drawing i.1 has 2 sets of dimensions: 1 from the walls to the center of the holes (on the
1 from the walls to the center of the holes (on the left and top of the drawing);
2 from the walls to the side of the cabinet (on the left and top of the drawing);
right and bottom of the drawing). 2 from the walls to the side of the cabinet (on the
right and bottom of the drawing).
Floor requirements.
Floor requirements. The floor should be:
The floor should be: - horizontal; within 2°
- - level; within 2 mm horizontal; within 2°
- - able to bear the weight of the balancer as stated level; within 2 mm
- in Chapter 2 of the Operator's Manual. able to bear the weight of the balancer as stated
in Chapter 2 of the Operator's Manual.
The floor on which the balancer will be installed
The floor on which the balancer will be installed should not relay vibrations from other devices or
should not relay vibrations from other devices or from outside the building. External vibrations will
from outside the building. External vibrations will affect the accuracy of the balancer.
affect the accuracy of the balancer.
Note: The balancer should be positioned on the
Note: The balancer should be positioned on the floor directly. Do not use shims to fill gaps.
floor directly. Do not use shims to fill gaps.
If the above conditions are met, you do not need to
If the above conditions are met, you do not need to secure the balancer to the floor, however if for
secure the balancer to the floor, however if for optimal performance balancer should be lagged to
optimal performance balancer should be lagged to the floor to prevent any accidental vibrations or
the floor to prevent any accidental vibrations or movement.
movement.
Power supply requirements.
Power supply requirements. Refer to Chapter 2 of the Operator's Manual for mains
power requirements. Refer to Chapter 2 of the Operator's Manual for mains
power requirements.
WARNING: ENSURE THAT AN APPROVED WALL
WARNING: ENSURE THAT AN APPROVED WALL MAINS OUTLET IS AVAILABLE.
MAINS OUTLET IS AVAILABLE.
WARNING: NEVER LAY POWER SUPPLY CABLES
WARNING: NEVER LAY POWER SUPPLY CABLES OVER THE FLOOR, UNLESS PROTECTED BY
OVER THE FLOOR, UNLESS PROTECTED BY AN APPROVED COVER.
AN APPROVED COVER.
Operator's Manual ACCU 1500