Accu-Turn 1500 Manuel De L'opérateur page 76

iii-1
iii-2
iii-3
iii-3a
76
Installation Instructions
iii Installation procedures. iii Installation procedures.
Wheel balancer:
Refer to the figure in section i to position the wheel
balancer correctly. If the wheel balancer is to be Wheel balancer:
secured, use concrete lags with a bolt shaft measuring Refer to the figure in section i to position the wheel
8 mm, quality 8.8 or above. balancer correctly. If the wheel balancer is to be
secured, use concrete lags with a bolt shaft
Storage hooks: measuring 8 mm, quality 8.8 or above.
• Unpack the 4 threaded accessory supports and
disks.
• Refer to Figure iii-1. Mount the 4 threaded supports
Storage pegs:
• Unpack the 4 threaded accessory supports and
and disks.
disks.
• Refer to Figure iii-1. Mount the 4 threaded supports
Stub shaft:
• Clean the stub shaft and the main shaft.
and disks.
• Refer to Figure iii-2. Position the stub shaft on the
main shaft.
• Use the key supplied to tighten completely.
Stub shaft:
• Clean the stub shaft and the main shaft.
• Refer to Figure iii-2. Position the stub shaft on the
Wheel guard:
• Refer to Figure iii-3. Bolt the wheel guard assembly
main shaft.
• Use the shaft tightening stud supplied to tighten
onto the shaft which projects at the back on the
completely. right-hand side.
Third Parameter Entry (3D Sape):
• Connect the cable on the guard to the cable that
Wheel guard:
• Refer to Figure iii-3. Bolt the wheel guard assembly
exits from the upper back side of the case. Firmly
onto the shaft which projects at the back on the right- connect the plugs and insert them in the case. Insert
hand side. the corrugated sheath in the special support hook
(Figure iii-3a).
Cones: Cones:
• Place the cones in the accessory supports. • Place the cones in the accessory supports or in
the molded spaces provided on the weight tray.
Clamping devices: Clamping devices:
• Place the clamping devices in the accessory
supports.
Operator's Manual ACCU 1500