Removal Of The Wheel; Preparation; Power Up; Emergency Stop - Accu-Turn 1500 Manuel De L'opérateur

5.2.1-1
5.2.1-2
5.2.2-1
30
Operations
5.1.3 5.1.3

Removal of the wheel.

Removal of the wheel.
• Carefully slacken the quick release wing nut or the • Carefully slacken the quick release wing nut or the
mounting studs. mounting studs.
• Do not drag the wheel on the balancers threaded • Do not drag the wheel on the balancers threaded
shaft, but lift the wheel when removing it. shaft, but lift the wheel when removing it.
• Check the thread for damage and clean if • Check the thread for damage and clean if
necessary. necessary.
5.2

Preparation.

5.2 Preparation.
• The operator should be familiar with the warnings
• The operator should be familiar with the warnings
and cautions
and cautions
• The operator should be qualified to work with the
• The operator should be qualified to work with the
balancer.
balancer.
• Always ensure that the wheel guard is raised when
• Always ensure that the wheel guard is raised when
the balancer is off.
the balancer is off.
5.2.1

Power up.

5.2.1 Power up.
• Do not keep any key pressed down during power
• Do not keep any key pressed down during power
up.
up.
Refer to Figure 5.2.1-1.
Refer to Figure 5.2.1-1.
• Plug the power lead into the power socket.
• Plug the power lead into the power socket.
Note: If the unit beeps and does not proceed or
Note: If the unit beeps and does not proceed or
if an error code is shown, refer to Chapter
if an error code is shown, refer to Chapter
7.
7.
The unit will beep and perform a self-test.
The unit will beep and perform a self-test.
All indicators and displays will be on for several
All indicators and displays will be on for several
seconds, so the operator may check if all displays
seconds, so the operator may check if all displays
and indicators are functioning.
and indicators are functioning.
The display and the weight position indicators relating
The display and the weight position indicators relating
to the current balancing mode will stay on.
to the current balancing mode will stay on.
Refer to Figure 5.2.1-2 for an example.
Refer to Figure 5.2.1-2 for an example.
The unit is now ready to begin the balancing procedure.
The unit is now ready to begin the balancing procedure.
5.2.2

Emergency stop.

5.2.2 Emergency stop.
To perform an emergency stop, refer to Figure 5.2.2-
To perform an emergency stop, refer to Figure 5.2.2-
1:
1:
• Select the STOP key to apply the electronic brake.
• Select the STOP key to apply the electronic brake.
• Apply the foot brake to stop the wheel.
• Apply the foot brake to stop the wheel.
When an emergency stop is activated due to an
When an emergency stop is activated due to an
unexpected action, rethink the steps taken:
unexpected action, rethink the steps taken:
Did the operator make an error or mistake?
Did the operator make an error or mistake?
Correct the input and continue working. No special
Correct the input and continue working. No special
procedure is to be followed.
procedure is to be followed.
Did the balancer do something unexpected?
Did the balancer do something unexpected?
• Read the relevant chapters again.
• Read the relevant chapters again.
Prepare the balancer for a restart:
Prepare the balancer for a restart:
- switch off the balancer
- switch off the balancer
- wait 20 seconds
- wait 20 seconds
- switch the balancer on again.
Operator's Manual ACCU 1500