Alu Special Mode (Hwm) - Accu-Turn 1500 Manuel De L'opérateur

5.3.2.8-1
5.3.2.8-2
5.3.2.8-3
5.3.2.8-4
44
Operations
5.3.2.8

ALU Special mode (HWM):

With the ALU Special mode, the exact distance where
the adhesive weight is applied on the internal and
external side of the ALU 4 mode is set.
• Press the "ALU" button until the "MOTO", "PAX"
and "ALU 4 or ALU 5" led simultaneously turn on.
The ALU Special procedure is now on (see Figures
5.3.2.8-1 / 5.3.2.8-2).
• Extract the internal detector arm and position the
probe on the point where the counterweight is to
be applied (Ver Figure 5.3.2.8-3), on the internal
plane, indicated by the left Led.
• Await the measurement completed acoustic signal,
and the internal plane LED starts to blink.
• Proceed with external plane reading (right Led).
• Subsequently extract the detector arm and perform
external plane reading, indicated by the right led.
• Await the measurement completed acoustic signal,
then manually accompany the arm to its original
position to obtain effective data entry.
• Perform a spin.
• Rotate the wheel to the WAP position of the left
plane.
• Extract the internal arm detector, the display signals
the missing distance from point 0 (zero) of
counterweight application.
• Arrange a weight as indicated on the display in the
Detector Arm applicator (Figure 5.3.2.8-4).
• When point zero is reached, rotate the arm towards
the rim and apply the adhesive weight.
• Move the arm back to idle position.
• At this step, you can choice to perform the Behind
Spoke Mode. If so, please refer to specific
procedure listed below, otherwise follow up with the
below described steps.
• Rotate and keep the wheel stopped in the
positioned specified by the right WAP indicator.
• Arrange a weight as indicated on the display in the
Detector Arm applicator.
• Extract the internal arm detector, the display signals
the missing distance from point 0 (zero) of
counterweight application.
• When point zero is reached, rotate the arm towards
the rim and apply the adhesive weight.
• Move the arm back to idle position.
• Perform a check spin.
Behind Spoke Mode.
Use this mode to hide adhesive weights behind the
spokes in aluminium radial wheels.
• Follow the instructions indicated for "ALU Special"
wheels through the end of internal counterweight
application.
Operator's Manual ACCU 1500