Accu-Turn 1500 Manuel De L'opérateur page 78

iii-4
78
Installation Instructions
• Place the clamping devices in the accessory
Weight Tray Plane:
• Rest the weight tray plane on the machine and,
supports.
before securing it, pass the keyboard connecting
Weight Tray Plane: cables to the outside: the cables are fed in from
• Rest the weight tray plane on the machine and than
the bottom of the Weight Tray Plane and exit
secure it with the two side screws (1-Fig. iii-4). through the top, where the keyboard will be
• Fit the two black self-tapping screws on the front
positioned.
• Fit the two side screws with metric pitch (1-Fig. iii-
(4-Fig. iii-4).
4).
Fit the two black screws on the front (4-Fig. iii-4)
User interface post: and tighten it normally on the case.
• Insert the cables of the user interface post in the
case, while positioning user interface post in its seat
Control panel: on the backside of the case.
• Connect the multi-track cable to the connector
• Fit the interface post in its seat tightening the
behind the panel.
• Connect the earth cable to the front panel.
provided screw.
• Apply the Control Panel, angled correctly, carefully
positioned at the centre of its seat on the Weight
Tray Plane.
• Press on the sides to make the Velcro tape adhere
correctly.
iv Test procedures.
• Balance a wheel to less than 0.25 oz. (5 grams)
per plane.
• Perform a User Calibration. See Chapter 6.3.1.
v Instructing the operator.
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
• Show the operator how to switch the unit on and
off.
• Show the operator how to perform an emergency
stop.
• Show the operator how to select a wheel type, enter
data and apply a weight.
Operator's Manual ACCU 1500