Accu-Turn 1500 Manuel De L'opérateur page 74

74
ii-1
ii-2
Installation Instructions
ii Handling, unpacking and contents.
Handling.
The wheel balancer is supplied on a pallet.
• Use a pallet truck (Figure ii-1) to bring the wheel
balancer to its working area.
Unpacking.
WARNING: PREVENT THE STRAPS FROM
SPRINGING LOOSE AFTER BEING CUT.
• Cut the straps.
• Open the top of the box.
• Remove staples at the bottom of the box. Lift the
box up and over the unit.
• Carefully unwrap the balancer and supplied parts.
• Check the contents of the shipment.
Contents.
The shipment contains:
- a wheel balancer
- a Declaration of Conformity (CE)
- the accessories as mentioned in Chapter 3 of
the Operator's Manual.
- 4 supports and disks for accessories
Tools required.
- bar (diameter 4.5-5 mm)
- Allan wrenches: 13, 17 mm
Positioning.
• Remove the bolts that secure the wheel balancer
on the pallet.
CAUTION: DO NOT LIFT OR MOVE THE WHEEL
BALANCER BY THE MAIN SHAFT OR
MEASURING HEAD.
• Refer to Figure ii-2. Move the wheel balancer from
the pallet to its working location.
Note: Use the accessory supports (mount as
indicated in Chapter iii) and/or wheel
guard shaft (if present) when handling the
unit.
Operator's Manual ACCU 1500