Weight Application - Accu-Turn 1500 Manuel De L'opérateur

5.3.4-1
5.3.4-2
5.3.4-3
5.3.4-4
48
Operations
5.3.4 5.3.4

Weight application.

Weight application.
The following weight types and application methods The following weight types and application methods
are available: are available:
- - clip-on weights. clip-on weights.
Always apply by hand. Always apply by hand.
- - stick-on weights. stick-on weights.
Depending on the type of wheel, apply by hand or Depending on the type of wheel, apply by hand or
using the gauge arm. using the gauge arm.
Note: Note: Weights applied manually must always be Weights applied manually must always be
fitted at exactly 90° to the axis (in the 12 fitted at exactly 90° vertical to the balancers
o'clock position). shaft (in the 12 o'clock position).
After spinning the wheel (refer to Figure 5.3.4-1): After spinning the wheel (refer to Figure 5.3.4-1):
• Look at the WAP indicators for the left plane of the • Look at the rotation indicators for the left plane of
wheel. the wheel.
If one or more indicators are lit: If one or more indicators are lit:
• Turn the wheel until all of the illuminated indicators • Turn the wheel until all of the WAP lights are lit
(Figure 5.3.4.-2). are lit (Figure 5.3.4.-2).
• Press the foot brake to lock the wheel. • Press the foot brake to lock the wheel.
The weight to be applied in that plane is shown on the The weight to be applied in that plane is shown on the
display. display.
Attaching a clip-on weight. Attaching a clip-on weight.
Refer to Figure 5.3.4-3. Refer to Figure 5.3.4-3.
• Clip-on weights must always be applied in the 12 • Clip-on weights must always be applied in the 12
o'clock position. o'clock position.
• The lip should rest on the edge of the rim. Use the
In STATIC mode only the left hand display is used. weight pliers to position it.
In STATIC mode only the left hand display is used.
Fitting a stick-on weight.
ALU or STATIC modes only: Fitting a stick-on weight.
ALU or STATIC modes only: Refer to Figure 5.3.4-4.
• Apply the weight on the rim in the 12 o'clock position
Refer to Figure 5.3.4-4.
• Apply the weight on the rim in the 12 o'clock position
with the correct offset from the "0" point.
with the correct offset from the "0" point. Note: With STATIC wheel types, always apply
Note: the weight at the rim center line. If not With STATIC wheel types, always apply
possible, split the weights evenly and the weight at the rim center line. If not
apply on another surface of the rim possible, split the weights evenly and
apply on another surface of the rim (symmetrical to the rim center line).
(symmetrical to the rim center line).
Operator's Manual ACCU 1500