Pax Wheel Balancing Mode; Alu Special Mode (Hwm) - Accu-Turn 1400 Manuel De L'opérateur

40
All manuals and user guides at all-guides.com
Operations
5.3.2.7
PAX SYSTEM wheels can be balanced with this function
(see Figure 5.3.2.7-1). When the PAX function is on,
the display is set for dimensions to be entered in mm as
required by this type of wheel.
•
Follow the operative instructions previously indicated for
ALU4 wheels.
5.3.2.7-1
5.3.2.8
With the ALU Special mode, the exact distance where
the adhesive weight is applied on the internal and
external side of the ALU 4 mode is set.
•
Press the "ALU" button until the "MOTO", "PAX" and
"ALU 4/ ALU 5" led simultaneously turn on.
The ALU Special procedure is now on (see Figures
5.3.2.8-1-2).
•
Extract the internal detector arm and position the probe
on the point where the counterweight is to be applied,
5.3.2.8-1
on the internal plane, indicated by the left Led.
•
Await the measurement completed acoustic signal, un-
til the display shows the offset read and the internal plane
led starts to blink.
•
Manually accompany the arm to its original position to
obtain effective data entry.
Proceed with external plane reading (left Led).
•
Newly extract the detector arm and perform internal plane
reading, indicated by the right led.
5.3.2.8-2
•
Await the measurement completed acoustic signal, then
manually accompany the arm to its original position to
obtain effective data entry.
•
Rotate the wheel to the WAP position of the right plane
and apply the weight.
•
At this step you can choice to perform the Behind Spoke
Mode. If so, please refer to specific procedure listed
below, otherwise follow up with the below described
steps.
•
Arrange the adhesive weight to be fastened to the inter-
nal side on the arm applicator.
•
Rotate and keep the wheel stopped in the positioned
specified by the left WAP indicator.
•
Extract the internal arm detector, the display signals the
missing distance from point 0 (zero) of counterweight
application.
•
Arrange a weight as indicated on the display in the De-
tector Arm applicator.
•
Rotate the arm towards the rim and apply the adhesive
weight.
•
Move the arm back to idle position.
•
Repeat the operation with the same procedure for the
external weight.
•
Perform a check spin.
Behind Spoke Mode.
Use this mode to hide adhesive weights behind the spokes
in aluminium radial wheels.
•
Follow the instructions indicated for "ALU Special" wheels
through the end of internal counterweight application.
•
Rotate the wheel to the right plane WAP position.
•
Press button "F".
"S 1" will appear on the right display.
•
Move the radial closer to the upper part in the 12 o'clock
position.
•
Press button "F".
"S - -" will appear on the right display.
•
Move the radial next to the first to the 12 o'clock posi-
tion.
Operator's Manual

PAX wheel balancing mode.

ALU Special mode (HWM):

ACCU 1420