Setting Up (Preparing For Work); Tools Used (Drill Bits) - Hettich BlueMax Mini Modular Instructions De Service

5. Setting up (preparing for work)

First select the appropriate interchangeable drilling unit. The
machine comes in 4 versions.

Tools used (drill bits).

First install the drill bits you need. This setting applies to all
interchangeable drilling units.
Insert required drill bit
1
the two screws using Allen key
7
When fitting, make sure drill bit's chucking face
positioned. The screws must clamp the bit in position at this
face.
Pre-mounted drill bits
Push pre-mounted tool
4
drilling unit and turn in opposite direction of drilling-unit
5
rotation.
The bayonet chuck engages.
Repeat this process until all tools are securely engaged.
Always close off unneeded tool holders with a dummy plug
Always check your work before fitting the interchangeable
drilling unit.
The drill bits must engage and all screws must be tight.
Note!
Pay attention to colour marking.
Drill bits marked red must be used for spindles turning anti-
clockwise.
Drill bits marked black must be used for spindles turning
clockwise.
Remove any oil residue from the interchangeable drilling unit
with a cloth.
into bayonet chuck and tighten
2
.
3
is correctly
8
into tool holder of interchangeable
.
6
4
6
7
8
1
2
3
5
137