Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Start-up / trial run
6. Start-up / trial run
1. Before first-time use
3. Malfunctions on start-up
1. Machine with article numbers:
9 131 498 and 9 131 499
Interchangeable drilling unit, 9 spindles,
Interchangeable drilling unit, 3 spindles, Selekta /
Interchangeable drilling unit, 6 spindles
Press-in frames for the interchangeable drilling unit,
122
1. Before first-time use
Note:
The machine is started up for the first time and
122
inspected for acceptance by skilled personnel from
122
Hettich FurnTech GmbH & Co. KG.
122
Before the machine is started for the first time, make sure the
described basic settings and trial runs have been made and
123
the machine is ready for operation.
The following checks must be made before start-up:
123
• check the machine for correct installation and alignment,
123
• check all screw connections at the various stations for
123
secure fit,
123
• check the safety guards for proper working order and
• check the power and compressed-air connections for proper
connection and secure fit.
123
2. Safety check
123
Satisfy yourself that:
123
• installation, set-up and servicing work have been completed
123
in full and no persons are present in the danger zone, let
124
alone working on it,
• all safety guards / covers are in place,
124
• the compressed-air supply is ready for operation, and
125
• the controls are freely accessible.
126
3. Malfunctions on start-up
129
On start-up, immediately switch OFF the power supply to the
130
machine if:
131
• unusual operating noises can be heard,
132
• the machine runs irregularly, oscillates or vibrates,
132
• tools malfunction,
133
• auxiliary units malfunction
133
• the motors consume too much power
134
• there are electrical faults, and
134
• tools overheat.
134
134
135
Danger!
Never put this machine into operation if work is still
being performed on this machine or on the electrics.
Establish the cause of any malfunction with the machine shut
down and made safe and have it rectified by a qualified and
skilled person trained to do so or eliminate the malfunction
yourself if you are in possession of the necessary qualification.
Caution!
Only switch the machine back on again once
malfunctions / faults have been properly and
completely rectified!
Publicité
Chapitres
Table des Matières
Dépannage
