Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting up
7. Setting up
1 . General information
Information for the machine setter
2. Getting ready
3. Tools / aids
Interchangeable drilling unit, 6 spindles,
Interchangeable drilling unit, 3 spindles (Selekta 22/9) 138
136
1. General information
Safety precautions
136
Any person given the task of operating, servicing and
repairing this machine or of altering its settings must have
136
read, understood and adhere to the operating manual, in
particular to the safety precautions.
136
The authorities and tasks of personnel operating this machine
136
must be clearly defined.
136
The work described in this section must only be carried out by
appropriately qualified personnel who are perfectly familiar
136
with this machine / system.
137
Information for the machine setter
137
All work involved in repairing, setting, troubleshooting and
servicing must only be carried out by duly instructed and
authorised skilled personnel. In the interest of safety, a second
person must be present during all work in case hazardous
138
situations occur.
138
2. Getting ready
139
Note!
139
Before setting the machine, familiarise yourself with
its controls.
140
141
Before you start setting:
141
• Look at the production job to find out which settings need
making.
142
• Check the machine for any damage.
142
• Make sure the machine is safe and in proper working order
143
before and after you switch it on.
144
• Make sure the described basic settings and trial runs have
been made and the machine is ready for operation.
144
• When switching the machine on, make sure no
145
unauthorised persons are present in the machine's work
145
area.
146
3. Tools / aids
• All tools and aids must be in proper working order.
4. Safety check
Satisfy yourself that
• installation, set-up and servicing work have been completed
in full and no persons are present in the danger zone, let
alone working on it,
• all safety guards / covers are in place.
Danger!
Never put the system into operation if work is still
being performed on this machine.
Establish the cause of any malfunction with the machine shut
down and made safe and have it rectified by a qualified and
skilled person trained to do so.
Or eliminate the malfunction yourself if you are in possession
of the necessary qualification.
Caution!
Only switch the machine back on again once
malfunctions / faults have been properly and
completely rectified!
Publicité
Chapitres
Table des Matières
Dépannage
