Emissions; Safe Machine Operation - Hettich BlueMax Mini Modular Instructions De Service

General safety rules

28. Emissions

Noise
Wear ear protection when performing very noisy work.

29. Safe machine operation

The machine is a semi-automatic machine for drilling panel-
type workpieces and inserting the fittings they require. Any
other use beyond this is deemed to be non-intended use. The
manufacturer / supplier shall not be liable for any damage
this causes. - The risk is borne solely by the user!
Only instructed persons must be allowed to work on the
machine.
Responsibilities at the machine must be clearly defined. The
machine operator must not allow persons to use the machine
if they have not received proper instruction. Instructions
detrimental to safety must be rejected!
The machine must be switched off before leaving it. Never let
machines runs unattended! Unplug, disconnect the machine
from the compressed-air supply and remove the drill bits.
Application
This machine must only be used for working on flat
panels made of wood-based materials, such as chipboard,
blockboard panels, MDF, solid wood or similar materials!
The manufacturer accepts no liability for any other uses.
Misuse of the assemblies set up on the machine, e.g. for
machining workpieces merely held by hand or improperly
clamped, may result in injury.
No unauthorised alterations must be made to the machine by
fitting it with safety-related add-on devices or equipment not
made by the manufacturer.
Wood must not have a moisture any higher than 8 to 12 %.
Work with particular care if workpieces project beyond the
edge of the work bench. In such instances, install a larger
support table or larger supports.
Secure the workpiece while you are working on it. Use the
hold-down clamps.
Tools
Only use tested and appropriate tools for mechanical feed!
Securely fasten tools!
Pay attention to the information provided by the
manufacturer on tools with clamping systems (also refer to
the section on changing drill bits in the operating manual).
Only use properly sharpened drilling tools.
Risk of trapping fingers!
Always operate the machine and insert fittings from the front.
Dust
Health hazards from wood dust!
Used with the extraction system provided, the machine
complies with dust protection regulations.
Some work processes and specific workpieces
(e.g. framed doors) do not permit full encapsulation and
extraction. In this case wear dust protection masks!
Odd pieces
Configure workpieces in a way that prevents odd pieces from
being catapulted out of the machine.
110 110
Machining forces
Match feed force and machining volume to the holding force
of the clamping equipment and to the workpiece material!
See Setting the drilling speed. If holding problems occur, use
additional stops or power clamps.
Fire risk
Grinding and welding work must never be performed on this
machine.
Fire risk!
Follow welding regulations and accident prevention
regulations.
Explosion protection
Machine is not explosion-protected. Do not install near paint
shops!