Hofmann geodyna 8200 Manuel Opérateur page 50

geodyna 8250p
50
5-8b
5-8
5-7b
Operation
5.2.2.1 Using the Automatic Lifter
Fig. 5-8b
The lifter ascends automatically as soon as the
operator operates the pedal for wheel removal.
After removing the clamping tool from the shaft.
– Support the wheel, then move the platform out
of the shaft area, towards the right.
– Press and release the control pedal; the platform
will be completely lowered.
– Roll the wheel off the balancer.
5.2.2 Unclamping the wheel
Note: While the jaws unclamp, support the wheel
WITH YOUR LEFT HAND so that it will not tilt
when unclamped.
 Lift the pedal (Fig. 5-8).
 Remove the clamping sleeve from the chuck (Fig.
5-7b).
 Remove the wheel.
(if present):