Hofmann geodyna 8200 Manuel Opérateur page 158

A
1
1
158
1
7-3
B
2 3
7-4
7-4a
Setting Parameters
7.4 Settings
Normal operation usually does not require any
modification of the factory–adjusted modes of
operation or their factory–adjusted statuses.
Variations, however, can be made by selecting certain
specific items in the SETTINGS screen.
In addition to the changes made to the functioning
modes, from this menu various counters can be
displayed showing the operations carried out over time
by the balancer.
Recalling the SETTINGS screen
 Select the SETTINGS Item (1, Fig. 7-3).
The SETTINGS screen Figure 7-4 will open and the
Basic List panel will be immediately active (1, Fig. 7-4),
(CATEGORIES).
The various items can be selected.
An active panel presents an illuminated edge (A).
When an item is selected the panel that contains it
turns a darker colour (B).
(1, Figure 7-4)
CATEGORIES
 Select a Category:
- General settings
- Setting Measurements
- Network and Printer connections
- Counters
- System information
This takes you to the central PARAMETERS panel
(2, Fig. 7-4).
(2, Figure 10-2)
PARAMETERS
 Select a parameter.
The selector shifts to the VALUES panel (3, Fig. 7-4)
so that changes can be made or information acquired.
VALUES
(3, Figure 7-4)
 Select the appropriate Item.
Note:
V a l u e s c a n n o t b e c h a n g e d i n t h e
Counters or Information categories.
 To return
to the INTRODUCTION screen,
key (1, Fig. 7-4a).
press the F1