Hofmann geodyna 8200 Manuel Opérateur page 126

8
8
8
126
5-87b
5-88
5-89
5-90
5-91
Operation
Figure 5-87b MINIMISATION "3"
 Rotate the wheel into marking position following the
arrows.
 In this position mark the tyre, on the outer side of
the wheel, precisely above the chuck.
 Confirm by pressing key 8.
The MINIMISATION "4" screen appears (Fig. 5-88).
Figure 5-88 MINIMISATION "4"
 On the tyre changer, turn the tyre with respect to
the rim until the valve is aligned with the mark made
on the tyre.
 Confirm by pressing key 8.
The MINIMISATION "5" screen appears (Fig. 5-89).
Figure 5-89 MINIMISATION "5"
Clamp the wheel.

Rotate the wheel until the valve is exactly

perpendicular to and above the chuck.
Confirm the valve position by pressing key 8.

The MINIMISATION "6" screen appears (Fig. 5-90).
Figure 5-90 MINIMISATION "6"
START is signalled on the screen
 Perform the wheel measuring run.
A measuring run is performed.
The MINIMISATION "7" screen, outside, is displayed
(Fig. 5-91) or the MINIMISATION "7" screen, inside,
appears (Fig. 5-93).
Indication H 0
Optimum condition has been achieved and cannot be
further improved.
Continue as shown on screen BALANCING (Fig.

5-83).