Select & Pre-Selected Chase Pattern Via The Button Mode; Select A Chase Pattern Through The Menu - ADB TANGO 24 Manuel D'instruction

< TIME eff pat
< SAVE
Those patterns are shown opposite :
= Light ON
= Light OFF
Lighting Technologies
Select & pre-selected Chase Pattern via the button MODE
A special selection of chase patterns may be selected with this button without
using the «MENU» button (see next paragraph). Every press of the button will
scroll through to the next available pattern. Only the following patterns are available
with this button :
Normal chase (1), Normal build (11), Chase inverted (13), Build inverted (23),
random channel flashing (25) and chase on memories 900 to 999 (26).
The pattern descriptions can be seen in figure 2.

Select a Chase Pattern through the Menu

To select from the full range of chase patterns select eff-mode from the set-up
menu. The display will now prompt for the pre-programmed Effect number. The
RECORD NEXT button will increment the number, and the RECORD LAST button
will decrement it. When the required number is showing on the display pressing
the button corresponding to the SAVE on the screen will accept the selection.
The patterns available can be seen in Figure 2.
By pressing «CHANNELS» and then «MODE», you come back to a normal chase.
Chase on memories 900 to 999
To create and run a chase pattern the individual steps need to be created and
stored in memories 900 to 999. When the memory chase pattern is now selected
the individual memories will scroll through at a rate dictated by the speed fader,
2 1
or it may be stepped through manually, as part of a show maybe, using the
SPEED control in the HOLD position and the «START/STEP» button.
Previewing an effect
By pressing the «MEMORY PREVIEW» button twice, the LED's can be selected
to show the output from the Effect section of the desk. So, you can look at an
effect "blind" and even change the mode or direction using the corresponding
buttons.
Afterwards, pressing any other button in the Preset (other than a flash button),
Crossfade/Playback, Effect or Master sections of the desk will cause the LED's
to revert to showing desk output.
TANGO
Page 21
Revision : 004