Deleting A Memory - ADB TANGO 24 Manuel D'instruction

TANGO
The modify mode may be exited at any time during this process by pressing the
«MODIFY» button a second time. The intensities on stage are changed but no
changes will be stored in the memory and the desk will return to normal operation.
So, if you only want to change intensities on stage (and not in the memory), you
must press «MODIFY» to enter the modify mode, move the faders, as described
earlier, and exit by pressing «MODIFY» a second time.

Deleting a Memory

Deleting a single memory, or a range of memories, is achieved via one of the set-
up menu options. Press the «MENU» button and then scroll through the options
until DELETE is found. Select this option and the display will now allow the entry
of a memory number. If a single memory is to be deleted use the RECORD NEXT
and LAST buttons to get the number displayed on the display. If a range of
memories is to be deleted display the lowest number in the range at this stage.
Select the NEXT option and the screen will change to show the previously selected
number twice. To delete a single memory press the YES option at this point to
delete. If a range is being deleted use the RECORD NEXT and LAST buttons
again to change the lower number to show the highest number in the range.
Once the range is defined select the YES option to delete the range selected.
The display will return to normal use.
To delete every memory the desk needs to be reset (or cold booted). This puts
the desk in the same state it was in when it left the factory. This facilities is available
via the «MENU» button.
Page 18
Revision : 004
< QUIT del.from
< NEXT 012 A
< QUIT del 012
< NEXT to 017
Lighting Technologies