Single Preset - ADB TANGO 24 Manuel D'instruction

TANGO

Single Preset

In single Preset mode the number of channels available in the manual section will be twice the
number available in dual Preset mode.
Assuming that all the Preset faders are at the bottom of their travel and that the Preset A master
fader is set to a value above 0 and that the «ON/OFF» button has not been pressed, i.e. the LED
is on. Also that the Grand Master fader is above 0 and it's associated «ON/OFF» button has not
been pressed. Moving a Preset fader off 0 will produce an output on that channel. If a dimmer
unit is connected to the output the lamp on that channel will light. Increasing the level of the
Preset fader will increase the light level of the lamp. Depending on the PREVIEW mode selected,
once the output level increases above a 5% the LED below that Preset fader will light, refer to
the Function of LED's & preview key section of this manual.
Once the output level increases above a 5% the LED below the Preset fader will light. Also if the
Preset master fader is over 5% the Preset A bank LED will light to show that the Preset is active.
Moving more Preset faders will light more lamps on the corresponding output channels as well
as the LED's below the faders on the desk.
Once a display of illuminated lamps has been created on the output the level of these lamps
may be varied in several ways.
• By moving each individual fader to vary it's output level.
• By changing the position of the Preset master fader A to after the output level of all the active
Preset channels.
• By moving the Grand Master fader to change the output level of the desk.
The action of the master fader is governed by the setting of the manual timer control.
If we consider the movement of the master fader, and call the start position posn. A and the end
position posn. B. If the timer is set to 0 then the output will change in time with the movement of
the master fader. If the timer is set to anything else then the output will change from the posn. A
to posn. B fader setting's in the time set. Whilst the output is still changing from one setting to
the other the RUN A LED above the timer will flash to show that the fade is still in progress. If the
master fader is moved again, say to posn. C, whilst a fade is in progress then the fade restarts,
at the new time setting (if changed), from posn. B to posn. C.
Note :
If the manual timer control is moved whilst a fade is in progress then the fade will restart from it's
current position to it's final position but will take into account the percentage complete of the
current fade i.e. If the fade was 50% complete and the manual timer was moved to 18 seconds
the fade would take a further 9 seconds to complete.
At any stage the output may be blacked out by using either of the «ON/OFF» buttons, in the
maunal Preset A, manual Preset B or the Grand Master sections. A Blackout state may also be
achieved by moving either master fader to 0. If a blackout is initiated, by pressing one of the
relevant «ON/OFF» buttons, whilst a fade is in progress, the fade will continue to it's end.
Page 12
Revision : 004
Lighting Technologies