Adding/Subtracting Area Measurements; Volume Measurement - TOOLCRAFT LDM-70BT Mode D'emploi

5. The calculated area is shown in the lower line.
6. Leave area measurement mode by pushing the button
(depending on the display, you may need to push the button several
times).
j) Adding/subtracting area measurements
Delete the measurements by pushing the button
the measurement.
1. Following the instructions contained in the chapter "i) Area
measurement" on page 54, carry out an area measurement.
2. Push the button
subtraction.
3. Push the button
4. The sum/difference of both areas is shown in the lower line.
5. Add/subtract further areas.
6. Leave area measurement mode by pushing the button
(depending on the display, you may need to push the button several
times).
k) Volume measurement
Delete the measurements by pushing the button
the measurement.
1. Turn on the device.
2. Push the button
longer side of the cube flashes.
3. Push the button
again to measure the length of the cube. The measured value is
moved to the upper line and the width of the cube flashes.
4. Repeat the above steps to measure the width and height of the cube.
5. After you measure the height of the cube, the calculated volume is
shown in the lower line of the display.
56
(15) for addition or the button
and carry out a second area measurement.
(16) until the display shows
to activate the target laser. Push the button
. Then repeat
(7) for
. Then repeat
(cube). The