Memory; Measuring; Water Level; End Piece - TOOLCRAFT LDM-70BT Mode D'emploi

11. Memory

The device features an internal memory that automatically stores
measured values to be retrieved later.
• There is a total of 20 memory slots available. When the memory is
full, each new measurement replaces the oldest stored value.
• The most recent value is saved to the first memory slot ( "01" ).
• Push the button
button to scroll through the stored values (you can also use the
buttons and
• Stored values are shown on the display with the symbol
number of saved measurements.
• To empty the memory, retrieve any stored value. Push and hold the
buttons
the entire memory.

12. Measuring

a) Water level
There is a water level (14) located on the side of the device. Use the
water level to make sure the device is in a horizontal position when
measuring.
b) End piece
The device features an end piece (11)
that may be of use when positioning.
1. Turn over the device.
2. Fold out the end piece.
3. Position the device for measuring
(ill. 1).
(8) to access the memory. Repeatedly push the
).
and simultaneously for approx. 1 second to empty
ill.1
and the
51