TOOLCRAFT LDM-70BT Mode D'emploi page 63

The stake out function allows you to determine two different lengths
(a, b) and then repeatedly measure (distance a) (see ill. 5).
1. Study ill. 5.
2. Turn on the device.
3. Push and hold the
switches to stake off mode.
4. Review the measurement reference setting (button ) and set as
required.
5. Use the buttons
your input with the button
your input. Length a flashes again.
» Push and hold the buttons
values [in 0.001 intervals (1 mm)].
» If you push and hold the button
the values are increased/decreased in 0.01 intervals (10 mm).
» The device saves these settings before turning off and they are
still available when you turn the device back on.
6. Push the button
» Push the button
7. Holding the target laser [target laser pointed at the starting object
(zero point)], move away from the starting object toward your first
target object (ill. 5).
» The next target distance is shown on the display (04).
» Heed the symbol
distance indicators (01) are displayed to show you which
direction to move in to reach your next target distance.
» The distance from the target distance is shown with a positive
(distance exceeded) or negative (distance fallen short of) value
(05).
button (4) for approx. 1 second. The device
to first determine length a and confirm
and
. Then determine length b and confirm
, to start stake out mode.
to stop the measuring procedure.
(A) on the display. Next to the symbol,
and to increase/decrease the
or for approx. 10 seconds,
63