TOOLCRAFT LDM-70BT Mode D'emploi page 59

Indirect measurement with two reference points (ill. 2)
1. Turn on the device.
2. Push the button
the hypotenuse, then the cathetus is measured.
3. When the hypotenuse of the symbol
to take a measurement. The measured value is moved to the upper
line. The next leg (cathetus)
4. Push the button
take a measurement. The measured value is moved to the middle
line. When measuring the horizontal leg, hold the device as level
as possible.
5. The calculated height is shown in the lower line.
Delete the measurement by pushing the button
Indirect measurement with three reference points (ill. 3)
1. Turn on the device.
2. Push the button
3. The first leg to be measured flashes in the symbol (
button to take a measurement. The measured value is moved
to the upper line.
4. Measure the next legs (heed the symbol). When measuring the
horizontal leg, hold the device as level as possible.
5. The calculated height is shown in the lower line.
Delete the measurement by pushing the button
(6) until the display shows the symbol
flashes.
to turn the target laser back on and again to
(6) until the display shows the symbol
flashes, push the button
.
.
. First
.
). Push the
59