Publicité
4
P
REPARATION
4.4
S
TARTING THE
Take note of the separate operating manual of the Remote control!
-
Remove lid of battery compartment on the lower side of the transmitter.
-
Insert 8 AA (rechargeable) batteries in the compartment,
observe the correct polarity!
-
Close the lid again.
-
Open battery box on the chassis and
-
remove the battery support of the battery box.
-
Place 4 AA batteries (rechargeable batteries) in the support.
-
Observe correct polarity and tightness.
-
Carefully connect both red plugs.
-
Place the battery support with the cables and the plug in the battery box
gain.
-
Close battery box, without clamping the cables.
-
Open receiver box and carefully remove the receiver
-
Unwind the wire of the antenna and guide it outwards through the opening
in the cover of the receiver box.
-
Guide the antenna of the receiver through the antenna guiding tube
-
and guide it out at the other end.
-
Insert the lower end of the antenna guiding tube in the opening on the
receiver box.
-
Fasten the antenna wire on the top at the guidance tube,
by wrapping adhesive tape around it or
by placing a rubber cap.
Do not shorten the antenna!
-
Switch the transmitter on.
The green LED lights up.
If the LED does not light up, check batteries /rechargeable batteries
and replace them, if necessary.
-
Switch on the receiver with the switch on the chassis.
The servos must turn in neutral position.
Always switch ON the transmitter first then the receiver.
First switch OFF the receiver, then the transmitter.
© REELY 09/07
All manuals and user guides at all-guides.com
RC I
NSTALLATION
45
Publicité
