Publicité
4
P
REPARATION
The Buggy Chassis Rex-X Promo II is pre-assembled ready to drive (Ready To Run).
Before the first start, some basic adjustments must be carried out or checked and the necessary
accessories and auxiliaries must be prepared.
Go through the various points of the check list one after the other, and your model is then ready to run.
Tuning measures on the chassis and/or the installation of another RC system necessitate various tools.
The latter are listed below.
4.2
T
OOLS AND AUXILIARIES
Tools
-
Socket wrench 17 mm for the wheel nuts
-
Flat spanner 5 mm
to set alignment and inclination
-
Flat spanner 5.5 mm
to change the shock absorbers (to counter-hold)
-
Allen key 3mm for the steering knuckle pins
-
Allen key 2.5 mm to change the shock absorbers
-
Allen key 2 mm for grub screws on the attachments
of cardan and drive shafts
-
Allen key 1.5 mm for the grub screws on the
adjusting rings of the throttle/brake and steering
linkages and the transverse stabilizers (optional)
Crosstip screwdriver (Ph No 1)
-
for all screws on the chassis, the casings of the
differentials and the RC mounting plate
-
Screwdriver for the throttle stop screw and the main
nozzle needle
The instructions specific to position front / back / right / left
always refer to the longitudinal axis of the vehicle
4.3
M
OUNTING THE CAR BODY AND PLACING THE DECORATIVE PATTERNS
The fastening elements for the car body are already pre-assembled in the contents of the delivery of the Rex-X Promo II
Chassis.
Before installing the car body, the boreholes for the car body supports and antenna passage must be mounted.
Use a special car body drill.
Installing the car body
-
Apply colored chalk or slow drying paint on the edges of the car body support and
-
Place the car body as exactly as possible on the chassis.
-
Remove the car body again and
-
Drill holes into the car body at the places marked with paint (chalk) for the
mounting parts of the car body.
-
Place the car body and fasten the latter with the car body splints
For a simpler handling, bent up the splints slightly.
-
Determine the position of the antenna tube on the car body and
-
Drill here also a hole for the antenna passage.
-
If necessary, make openings for the starter cord, the tank shutter and the cooling head.
The car body of Rex-X Promo II is already cut and painted!
-
The decorative patterns are glued on the outside of the car body.
-
Moisten the car body and the decorative patterns with a light washing-up liquid before placing them.
This gives you some time to reposition the decorative patterns and to flatten air bubbles.
-
Fine details such as window frames, door sections or borders can be drawn with conventional decorative strips or
waterproof markers.
44
All manuals and user guides at all-guides.com
,
CHECK LIST FOR PUTTING INTO OPERATION
NOTE!
in drive direction "forward"!
A
UXILIARIES
-
Cable fastener
-
Air filter oil
-
Low viscosity machine oil for lubrication and
to protect the combustion chamber against corrosive
residues in the engine, after operation („After Run")
C
HECK LIST FOR PUTTING INTO OPERATION
What must be done:
-
Check alignment and tooth backlash of drive
-
Function control of servos
-
Check the range of the remote control transmitter
-
Check basic carburettor setting
-
Fill in fuel
-
Let engine run
Operating manual 4WD Buggy Chassis Rex-X Promo II No. 23 50 00
Publicité
