Publicité
146671AB_Neox_manual_NL EN FR DE.indd 27
146671AB_Neox_manual_NL EN FR DE.indd 27
Leg rests
Swivel and/or remove the leg rests
1. Pull the lever (C) upwards and rotate the legrest
outwards or inwards at the same time.
2. If the leg rest is turned outwards, it can be lifted
straight up from the frame.
Positioning the leg rests
1. Rotate the leg rest a quarter turn outwards from
C
C
the mounted position and lower it into the ope-
ning provided
2. Rotate the leg rest forward until it clicks into place.
Warning:
•
Adjusting the lower leg Length
1. Loosen the Allen screw (D)
2. Slide the insert tube further in or out of the sus-
pension tube until the desired lower leg length is
reached.
Note:
D D
•
3. Tighten the Allen screw (D).
Adjusting the Knee Angle
1. Remove the countersunk bolt (A) in the ankle joint
and footplate
2. Loosen the Allen screw on the underside of the
leg rest (B).
3. Remove the single pivot point from the plug-in
tube and rotate it 180 degrees.
4. Replace the single pivot point in the plug-in tube
B B
and re-tighten the Allen screw (B).
5. Replace the footplate against the pivot point and
A A
retighten the countersunk bolt (A) in the ankle
joint.
If a push brake is fitted, make sure that the
leg rest cannot unintentionally release the tire
brake when swinging outwards.
It is advised to keep at least 5 cm of verti-
cal distance between the footplate and the
ground.
EN27
28-5-2024 13:55:17
28-5-2024 13:55:17
Publicité
