Publicité
X X
A A
C C
E E
X
X
1
W34,5
2
W37
3
W39,5
4
W42
5
W44,5
6
W47
7
W49,5
8
W52
9
W54,5
10 W57
146671AB_Neox_manual_NL EN FR DE.indd 19
146671AB_Neox_manual_NL EN FR DE.indd 19
Seat width and back width
A. Frame Settings
The seat width of the wheelchair is adjustable by the
width-adjustable folding frame and the width-adjus-
table upholstery. And can be adjusted in steps of 2.5
cm from 34.5 cm to 57 cm.
The size 1 folding frame has an adjustment range of
34.5 to 49.5 cm. And the folding frame size 2 has an
adjustment range of 42 to 57 cm.
Adjusting the seat width of the folding frame
1. Remove the seat cushion.
2. Remove the cover caps (X) and the upholstery
screws on the front and rear of the seat frame
tubes and the top and bottom of the back tubes
B B
D D
3. Slide the upholstery rails with the upholstery
forwards out of the seat frame tubes and up out
of the back frame tubes.
F F
4.
Loosen the 6 Allen screws (A to F) of the folding
frame.
5. Extend the folding frame to the desired seat
width (teeth for every 1.25 cm, resulting in
increments of 2.5 cm at a time). See the table on
the right for which number of the folding frame
should be visible for which seat width.
Waarschuwing:
•
6. Retighten the 6 Allen screws (At/m F). (tightening
torque 10 Nm).
Make sure that the left and right sides of the
folding frame are set to the same number of
teeth.
EN19
28-5-2024 13:55:12
28-5-2024 13:55:12
Publicité
