Publicité
Inspired by life
4. Adjust the angle of the fork relative to the floor
to 90 degrees.
5. Retighten the Allen screws..
Warning:
•
As this is difficult to see, you can check this
by driving the chair forward and backward
slightly, with the caster fully swinging from
back to front. If the castor axle is vertical,
there is no measurable or visible difference
in height between the frame tubes and the
substrate during this operation.
Adjusting tire brakes
When changing the seat height, seat depth, seat
angle and balance point, it is necessary to readjust
the tire brakes.
Rough adjustment
1. Loosen the Allen bolt (A) on the underside of the
brake clamp.
2. Slide the brake forward or backward through
the seat frame tube until the desired position in
relation to the tire is reached.
3. Retighten the Allen bolt (A) on the underside of
the brake clamp.
Warning:
•
In certain configurations, the tire brakes are
mounted on the front module. Then it is not
possible to use the rough adjustment, only the
fine adjustment.
Fine adjustment
1. Loosen the Allen bolt (B) at the top of the brake
clamp.
2. Set the band brake to the desired position.
3. Retighten the Allen bolt (B) at the top of the
brake clamp.
EN24
146671AB_Neox_manual_NL EN FR DE.indd 24
146671AB_Neox_manual_NL EN FR DE.indd 24
A A
B B
28-5-2024 13:55:16
28-5-2024 13:55:16
Publicité
