Publicité
A A
C
C
146671AB_Neox_manual_NL EN FR DE.indd 21
146671AB_Neox_manual_NL EN FR DE.indd 21
Seat depth
The seat depth can be adjusted by stepless sliding
the rear module over the side frame.
1. Loosen the 4 Allen screws (A to D) on both sides.
2. Slide the rear module over the side frame to
B B
the desired seat depth position (see seat depth
indication on the inside of the upper seat frame
tube).
3. Retighten the 4 Allen screws (A to D) on both
sides. (tightening torque 10Nm)
D D
Warning:
•
Make sure the rear module is mounted at the
same depth on the left and right.
•
If the position of the back frame prevents you
from sliding the rear module to the correct posi-
tion, adjust the back depth position according to
the instructions on p. 22.
Seat depth adjustment range per side frame:
•
Short frame: SD 40 cm - SD 48 cm
•
Long frame: SD 46 cm - SD 56 cm
Back Depth Position / Fine Adjustment of Seat
Depth
The position of the back support can be adjusted
extra precisely by moving the back tubes over the
seat frame tube (inside the rear module). The middle
position between the rear module is the standard
position.
1. Loosen the 2 Allen screws (C) of the back depth
C C
adjustment.
2. Slide the back tubes tubes to the desired depth
position.
3. Retighten the 2 Allen screws (C). (tightening
torque 10 Nm)
Warning:
•
Make sure the back tubes are mounted at the
same depth on the left and right.
EN21
28-5-2024 13:55:14
28-5-2024 13:55:14
Publicité
