Publicité
Inspired by life
Adjusting the width position of the side shield
1. Lift the T-piece armrest out of the side holder.
2. Remove the height stop from the T-piece by
loosening the Allen screw.
3. Slide the mounting blocks (A) out of the insertion
tube of the armrest and split it into 4 loose
blocks.
4. Slide the 2 threaded mounting blocks into the
plug-in tube.
5. Place the 2 additional blocks on the 2 threaded
mounting blocks and place the side shield on
top.
6. Assemble this assembly with the 2 bolts sup-
plied.
Fix the armrest
1. Slide a thin square nut down behind the height
stop.
2. Insert a countersunk bolt (D) into the hole and
tighten the bolt into the square nut.
Adjusting the depth of the side shields.
1. Remove the 2 countersunk bolts (C).
2. Place the side shield in the desired position.
3. Retighten the 2 countersunk bolts (C).
Adjusting the height of the side shields.
1. Loosen the 2 countersunk bolts (C).
2. Slide the side shield up or down.
3. Retighten the 2 countersunk bolts. (C)
Replace the armrest
1. Remove the 2 countersunk bolts (E) on the
bottom of the armrest.
2. Remove the armrest and replace it with a new
one.
3. Retighten the 2 countersunk bolts (E).
EN26
146671AB_Neox_manual_NL EN FR DE.indd 26
146671AB_Neox_manual_NL EN FR DE.indd 26
E
E
B
B
A A
D D
C
C
28-5-2024 13:55:16
28-5-2024 13:55:16
Publicité
