Publicité
Inspired by life
B. Seat upholstery adjustment
1. Slide the two upholstery rails (A) into the correct
seat width size indication (C) on the end of the
seat width tunnels (B) of the upholstery.
2. Fold the end of the upholstery around the rails.
Make sure that the rails themselves are not
folded over, so the 'fold line' is outside the rails,
see also the size indication numbers on the
upholstery (C)
3. Place the left and right upholstery tools on the
end of the frame tubes.
4. Fold the folding frame slightly, just like the back
frame, and slide both rails (with the upholstery)
into the tubes of the seat frame at the same
time, using the upholstery tool
5. Screw the upholstery screws on the front of the
upholstery into the tunnels where the upholstery
rails are located.
6. Replace the cover caps (X) at the ends of the
seat frame tubes.
C. Back upholstery adjustment
1. Slide the upholstery tendon (A) into the correct
back width size indication (C) on the back width
tunnels (B) of the upholstery.
2. Fold the end of the upholstery around the rails.
Make sure that the rails themselves are not
folded over, so the 'fold line' is outside the rails,
see also the size indication numbers on the
upholstery (C)
3. Fold the folding frame slightly, just like the back
frame, and slide both rails into the tubes of the
back frame at the same time, using the uphol-
stery tool
4. Tighten the upholstery screws on both sides of
the front of the upholstery in the tunnels where
the upholstery rails are located.
5. Replace the cover caps (Y) on the top and
bottom of the left and right back tube.
EN20
146671AB_Neox_manual_NL EN FR DE.indd 20
146671AB_Neox_manual_NL EN FR DE.indd 20
C
C
B B
C
C
B
B
A A
Y
Y
28-5-2024 13:55:14
28-5-2024 13:55:14
A A
Publicité
