Publicité
Inspired by life
Adjustment of the back angle (in case of an adjus-
table back angle)
4. Loosen the Allen screw (A) on both back corner
hinges on the back.
5. The indicator line on the side of the back angle
hinge shows the standard Newton hip angle of
103 degrees (angle between backrest (LT plane)
and seat).
6. Retighten both Allen screws (A).
Warning:
• The backrest angle adjustment may only be car-
ried out without an occupant.
• Make sure the left and right back tubes are
mounted at the same angle.
Backrest Height Adjustment
7. Loosen the 2 Allen screws (B) from the height
position of both back tubes.
8. Slide the back tubes to the correct LT plane
height (see indication from 0 to 8 on back tubes)
The NEOX configurator indicates the correct
height position of the backrest based on your
client's LT flat height.
9. Retighten the 2 Allen screws (B) on both back
tubes. (tightening torque 10 Nm).
Note:
•
Make sure the left and right back tubes are
positioned at the same height.
•
Check that the back tube is properly fastened
before anyone uses the chair.
Balance Point
The balance point of the NEOX can be adjusted to
your client's needs. The NEOX configurator gives
you advice on a suitable balance point setting for
your client.
EN22
146671AB_Neox_manual_NL EN FR DE.indd 22
146671AB_Neox_manual_NL EN FR DE.indd 22
A A
B B
28-5-2024 13:55:15
28-5-2024 13:55:15
Publicité
