Publicité
Inspired by life
3. Retighten the 2 Allen screws (A).
4. Repeat for the other front wheel.
Adjusting the height position of the front wheel in
the fork
1. Loosen the front wheel axle nut and remove the
axle.
2. Place the front wheel back in the desired height
position according to the NEOX frame height
table or the advice of the NEOX configurator.
3. Replace the shaft and tighten the nut.
Frame height at the back of the wheelchair
1. Remove the rear wheel by pressing the button in
the middle of the wheel.
2. Loosen the 2 axle plate bolts (A & B) and remove
the axle plate from the rear module.
3. Place the axle plate in the correct height position
on the rear module according to the NEOX
frame height chart or the advice from the NEOX
configurator, insert the 2 Allen screws (A & B)
and tighten them. (tightening torque 10Nm)
4. Insert the rear wheel back into the axle bushing
(C).
5. Repeat for the other rear wheel.
Note:
•
Make sure the left and right axle plates are
mounted at the same height.
•
After adjusting the frame height, always check
the head angle adjustment and the adjustment
of the tire brakes (see page 23 onwards)
EN18
146671AB_Neox_manual_NL EN FR DE.indd 18
146671AB_Neox_manual_NL EN FR DE.indd 18
1
2
3
4
5
Positions 1 to 5 correspond to the
height of the wheel in the clevis.
A A
C C
B B
28-5-2024 13:55:09
28-5-2024 13:55:09
Publicité
