Publicité
// USER MANUAL
Components
stem handlebar clamp
stem steerer clamp
Pivot points rear end
*This torque is a value which must not be exceeded. Normally, a lower torque is sufficient for a safe connection. Especially when using assembly paste, the torque can often be reduced significantly below
this value, as the solid particles in the assembly paste increase the friction significantly.
Tip: The lower the tightening torque of the screws, the less stress is placed on the component - this is particularly important for carbon components.
7.4
TIRE PRESSURE
The maximum tire pressure depends on the tire width and the inner rim width. The following table might be of help when adjusting the tire pressure. Do not exceed the maximum tire pressure! On bikes with
originally fitted tires, the maximum tire pressure can be determined from the tire width. You can find the tire width on the sidewall of the tire. On mountainbikes, it makes sense to choose a tire pressure that
is lower than the maximum pressure for higher grip. The minimum tire pressure is also marked on the tire sidewall and you should not fall below this value. The tire pressure for trail, enduro, freeride and
downhill use should be about 1.5 to 1.9 bar at the front wheel and about 1.7 to 2.1 bar at the rear wheel.
7.5
REPLACING COMPONENTS
Not all parts on your e-bike may be replaced without further ado. The two associations "Zweirad-Industrie-Verband" (ZIV) and "Verbund Service und Fahrrad" (VSF) have developed a guideline. This guideline
defines the conditions under which e-bike components may be replaced. The components of your e-bike are divided into four categories:
CATEGORY 1: COMPONENTS THAT MAY ONLY BE REPLACED AFTER APPROVAL BY THE DRIVE MANUFACTURER OR PROPAIN BIKES.
• Drive unit
• Sensors
• Electronic control
• Electrical cables
• Control unit on handlebar / display
• Battery pack / charger
CATEGORY 2: COMPONENTS THAT MAY ONLY BE REPLACED AFTER APPROVAL BY PROPAIN BIKES.
• Frame
• Shock
• Rigid or suspension fork
• Brake system
• Pannier rack (racks directly affect the load distribution on a bicycle. Both negative and positive changes potentially result in different driving behavior than implied by the manufacturer).
94
Manufacturer, Model
SIXPACK
SIXPACK
PROPAIN
Tightening torque
6 Nm
6 Nm
see assembly instructions
Publicité
