Publicité
// MOUNTING THE PEDALS
1
R
One of your pedals has a right-hand thread and the other a
left-hand thread. Most pedals are marked with "L" and "R" for
the mounting side. On some pedals, the left pedal is marked
with a groove on the axle.
1.
Slightly grease pedal thread.
2.
Turn the left pedal counterclockwise into the thread in
the left crank arm and tighten the pedal with a tightening
torque of 35 Nm.
3.
Turn the right pedal clockwise to screw it into the thread
of the right crank arm and tighten the pedal to a torque
of 35 Nm.
// ADJUSTING THE SEAT HEIGHT
3
L
Attention: When adjusting the seat height, the cable of the seat post must be pushed or pulled in or out the frame. Otherwise the
cable may get damaged!
1.
Open the saddle clamp.
2.
Push the seat post carefully and slowly into the frame or pull the seat post out of the frame. At the same time push or pull the
cable in or out the frame.
3.
Close the seat post clamp.
Publicité
