Publicité
// USER MANUAL
COMPONENT
TASK
Headset
Disassemble, clean, grease and reassemble all parts of the headset. Replace poorly running or corroded bearings.
Seatpost
Disassemble, clean the seat post and seat tube of the frame and assemble it without using lubricants.
Check the tightening torque. Torque of the seat post clamp and saddle clamp, see „7.3 Torques" on page 93.
Handlebars / Stem
Check the tightening torque. Torque values, see „7.3 Torques" on page 93.
Brakes
Check the wear of the brake pads. The brake pad on the metal backing plate must be at least 0.5 mm thick.
Check the brake rotors for wear. Minimum thickness of the brake rotors: 1.7 mm
Bleeding the brakes / changing the brake fluid
Wheels
Servicing the hub:
under normal conditions of use
In case of extreme operating conditions (regular rides in dust, rain, snow, or in
case of frequent transport while raining)
Maintenance activities, see manufacturer' s instructions.
Check the spoke tension, dish and wear of the wheel.
Tires
Remove the tires and check them for damage and embedded foreign objects.
Gears / drive system
Check wear of the chain with a chain wear gauge.
The chain must be replaced when the maximum permissible elongation is measured with the chain wear gauge.
The chainrings and the cassette should also be replaced when replacing the second chain.
Check the adjustment of rear derailleur and front derailleur.
When using an electronic gearshift or electronically dropper seat post: Change button cells.
Battery type: CR2032
*h = operating hours For intervals with km- and h-intervals, the event that occurs first applies.
92
INTERVAL
6 months
3 months
3 months
regularly
regularly
12 months
12 months
3 months
10 h*
3 months
for the first time after 1000 km, then regularly
3 months
2 years
or when red LED is on/blinking
Publicité
