Publicité
//TURNING THE STEM STRAIGHT AND MOUNTING THE HANDLEBAR
1.
Open the clamping bolts (C) and turn the stem in riding direction.
2.
Unscrew the clamping bolts (A/B). Remove the handlebar clamp and the bolts.
3.
Attach the handlebar to the stem, attach the handlebar clamp and turn the screws in by hand a few turns.
4.
Turn the handlebars in riding direction, center the handlebars and adjust the tilt of the handlebars according to personal preference.
5.
Adjust the brake levers and the shifters to the angle of the handlebar.
6.
Tighten the two clamping screws C alternately until a torque of 6 Nm is reached.
7.
Turn in the two upper clamping screws and tighten both screws with the torque lasered on the clamp or stem.
8.
Turn in the two lower clamping screws and tighten both screws with the torque lasered on the clamp.
→ There must be no gap between the stem and the clamp on the top side of the stem. On the other hand, a gap must be visible on the
underside.
No Gap
A
A
C
C
B
Gap
6 Nm
A
B
6 Nm
C
6 Nm
On some models the SIXPACK Millenium
ICR stem with integrated cable routing is
installed.
To change the
stem height, refer
to the SIXPACK
instructions.
Scan the QR
code for more
information.
B
Publicité
