Dimensions And Mounting Steps - Kübler Sendix 58 FS2 Instructions D'utilisation

4.1.3 Dimensions and Mounting Steps

Reference to the data sheet
The technical drawing with complete dimensioning can be
found in the data sheets of the corresponding variant of the
device, for special versions in the.corresponding customer
drawing of the product.
The illustrations below only show a selection of examples. All
values without unit in the picture are given in mm [inch].
In order to simplify the drawings and information, unless oth-
erwise specified, the general tolerances with tolerance class
m (medium) according to ISO 2768-1 apply.
4.1.3.1 Solid Shaft Encoders
Di- 5814FS
men- Incremental
sion
a 38 [1.50]
D = Shaft Shaft fit
diameter
10 [0.39] f7
48 - EN
NOTICE
5853FS 5863FS
Singleturn Multiturn
Absolute Absolute
38 [1.50] 49,5 [1.95]
L = Shaft length
20 [0.79]
Clamping flange, solid shaft with key
3xM3, 6 [0.24] deep
3xM4, 8 [0.32] deep
Feather key DIN 6885 - A - 3x3x6
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 04
18014398571058571