Screw Retention - Kübler Sendix 58 FS2 Instructions D'utilisation

0,1
Ra 1,6
ATTENTION
Encoder damage
Device failure, device lifetime reduction.
• Comply with the minimum insertion depth of the drive in the
hollow shaft encoder.
For tapered shaft encoders
Material: Steel
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 04
A
53088907

4.1.4 Screw Retention

Secure the fastening screws against loosening. This is
achieved, depending on the application, using e.g.
• Coated screws
• Threadlocker
• Schorr washers
Kübler recommends a threadlocker, e.g. Loctite (order code:
8.0000.4G05.0000).
We recommend an additional protection against manipulation
by marking the fastening screws with locking varnish or sim-
ilar.
Ra 1,6
2° 51´ 45´´ 0
0,02 A
±0,1
2 7,5
1:10
18014398562568459
-1-
EN - 53