Publicité
en
Parameters
Address
Baud rate
Frame parity
Table 5: Parameters
NOTICE
By default, the pump waits for initialisation after being switched on.
To find out more about how to handle the Modbus interface, please contact the Wilo technical support.
6.3
Other functions
Venting
The pump venting function vents the pump automatically.
The heating system is not vented.
For information on activation, see section "Commissioning".
Deblocking
When the motor is blocked, the pump automatically starts a specific routine with a high torque to remove
the blockage.
The routine takes a maximum of around 30 minutes.
See section "Faults, causes and remedies" for the manual activation procedure.
Factory setting
This function makes the pump run with the factory settings (delivery condition).
This function is present only on version "F02".
See section "Commissioning" for the activation procedure.
Key lock
62
Installation and operating instructions • Wilo-Para MAXO/-G/-R/-Z • Ed.04/2024-11
Standard value
101
19,200 kbps
8E1
Publicité
