Publicité
Saphir
Then remove air filter from the front�
Reassemble the cleaned or changed air filter
(Fig� 24-1)� Make sure that the air filter is correct-
ly aligned, as indicated by the arrow printed on it
(Fig� 24-3)�
Re-fit the Saphir US lamellar insert (Fig� 24-1), clip
and sensor in the same position during assembly�
Re-fit the cold air ducts�
3
1
2
Fig� 24
NOTICE
Operating the device without a filter can
cause evaporator coil soiling, which can
have a detrimental effect on the perfor-
mance of the device!
When installing the air filter, the printed
arrows (Fig� 24-3) must point towards the
device – they indicate the circulated air flow
direction�
Never operate the device without a filter�
40090-00130 · 01 · 11/2023
8.2
Insert/change batteries
The battery cover is on the rear of the remote control
(Fig� 25)�
When removing the batteries, pairing between the
remote control and the air conditioning system is
maintained� The time and timer are not maintained�
Only use leakproof micro-batteries, type LR 3, AM4,
AAA, MN 2400 (1�5 V)�
Observe the positive/negative positions when insert-
ing new batteries�
Then set the time and timer again�
Fig� 25
Low used batteries can leak and damage the remote
control�
Remove batteries when the remote control will not
be used for longer periods�
Maintenance
EN
17
Publicité
