Publicité
Operation
6.13 Set clock
After replacing the battery, when changing to or from
daylight saving time, or when changing to a different
time zone, you have to set the time manually� If a timer
is active, the clock cannot be changed�
Press the TIME
button�
The time is shown flashing on the display�
Set the current hour with the HOURS
HOURS
buttons�
Set the current minute with the MIN
MIN
buttons�
Press the TIME
button again or wait approx�
10 seconds�
The time is shown on the display�
The time is set�
The clock shows 12:00 pm at noon� At midnight it
shows 12:00 am�
6.14 Set timer
Two timers can be programmed�
Timer ON
•
The air conditioning system is off� The time set in the
timer determines when the air conditioning system
is switched on�
Timer OFF
•
The air conditioning system is on� The time set in the
timer determines when the air conditioning system
is switched off�
The timer can be set in a range of minimum 15 minutes
to maximum 24 hours� Times set in the timer of less
than 15 minutes are rounded up to 15 minutes�
Only one timer can be active at one time�
If a timer is active, all buttons except
ON/OFF
, RESEND
, TIMER
have no function�
Times set in the timer are only sent to the air condi-
tioning system when the TIMER
buttons have been pressed�
If the remote control goes to stand-by mode after ap-
prox� one minute and a timer is active, then, next to the
current time, the timer set time is shown on the display
with the corresponding timer ON or timer OFF icons�
When the timer has been programmed, no further
communication between the remote control and the
IR receiver is required for the timer function to operate�
After programming, the remote control can be placed in
the holder or a drawer�
14
EN
6.14.1 Program timer ON
Switch the air conditioning system on with the re-
mote control�
The air conditioning system runs with the previously
selected settings�
Set the desired operating mode and room tempera-
ture�
and
Press the TIMER
The timer ON icon is shown on the display�
and
The timer flashes�
Set the timer set time with the HOURS
HOURS
Set the minutes with the MIN
buttons�
Confirm the setting with the TIMER
The time set in the timer is shown on the display
with the ON icon�
The time set in the timer is sent to the air condition-
ing system�
The green LED on the IR receiver flashes briefly�
The air conditioning system switches off and the
timer starts�
Wait approx� one minute while the remote control
goes to stand by� If the ON/OFF
after timer programming, the air conditioning sys-
tem switches on again and the time set in the timer
is deleted�
When the time set for timer ON is reached, the air con-
ditioning system starts automatically with the previous-
ly selected settings�
6.14.2 Program timer OFF
Switch the air conditioning system on with the re-
mote control�
The air conditioning system runs with the previously
selected settings�
and TIMER
Set the desired operating mode and room tempera-
ture�
Press the TIMER
The timer OFF icon is shown on the display�
or TIMER
The timer flashes�
Set the timer set time with the HOURS
HOURS
Set the minutes with the MIN
buttons�
Confirm the setting with the TIMER
The timer is shown on the display with the OFF icon�
The time set in the timer is sent to the air condition-
ing system�
The green LED on the IR receiver flashes briefly�
The air conditioning system runs with the previous
settings and the timer starts�
button�
buttons�
and MIN
button is pressed
button�
buttons�
and MIN
40090-00130 · 01 · 11/2023
Saphir
and
button�
and
button�
Publicité
