Publicité
Saphir
Wait approx� one minute while the remote con-
trol goes to standby� If the ON/OFF
pressed after the timer programming, the air condi-
tioning system switches off again and the time set in
the timer is deleted�
When the time set for timer OFF is reached, the air con-
ditioning system switches off automatically�
6.14.3 Switch timer off
Press the TIMER
or TIMER
No timer is shown on the display�
The green LED on the IR receiver flashes briefly�
The timer is switched off�
6.15 Reset
The remote control settings can be reset to the factory
settings with the reset button�
Press the RESET button
pen, for example�
All icons flash briefly on the display� The remote control
switches off and the air conditioning system continues
to run unchanged� The next time the remote control is
activated, the default factory settings are set�
Factory settings:
Operating mode: Circulated air
•
Fan: Low
•
Time: 12:00 pm
•
Timer: Off
•
Temperature: 72 °F (22 °C)
•
6.16 Resend
Sending settings to the air conditioning system can
fail if, for example, the remote control was not pointed
precisely at the IR receiver� In this case, the previously
selected settings can be sent again�
Press the RESEND
The send icon
is shown briefly on the display�
The green LED on the IR receiver flashes briefly�
Settings are sent�
6.17 Set time format
The time on the display can be shown in the 12 or
24-hour format�
Press the TIMER
and TIMER
the same time�
The time format changes between AM / PM and
24-hour format�
If a timer is activated, the timer must be switched off
via the remote control and programmed again�
40090-00130 · 01 · 11/2023
button is
button again�
for 3 seconds, with a
button�
buttons at
7
Cleaning
NOTICE
Damage to the device caused by water
ingress through openings in vehicle under-
body
When cleaning the vehicle floor with a
high-pressure water blaster, avoid the area
around the supply air inlet and outlet�
Do not use any abrasive cleaning agents or sharp
objects� Use a soft, damp cloth to clean the air con-
ditioning system�
Do not use gasoline, diesel, solvent, chemical clean-
ing agents, alcohol, surfactants or plasticisers for
cleaning�
7.1
Clean supply air inlet and outlet
Keep the air conditioning system's air inlets and air
outlets in the vehicle floor free of obstructions, e�g�
dirt or foliage, to ensure optimum performance and
optimum air flow rate� Otherwise, the function of the
air conditioning system will be adversely affected,
which may result in damage�
NOTICE
Water in the air conditioning system can
cause damage and malfunctions.
Do not clean the air conditioning system with
a hot/steam cleaner or high-pressure cleaner�
If cleaning the vehicle with a hot/steam
cleaner or high-pressure cleaner, do not
spray directly into the air conditioning sys-
tem's openings�
When the vehicle underbody is being
cleaned, it must be ensured that no water
penetrates the openings in the base of the
device� Do not point a high-pressure water
jet, for example, directly into the openings�
7.2
Clean condensation trap
The condensation trap is under the vehicle floor� In
order to allow the condensation to drain away freely,
check unobstructed trap at regular intervals� Failure
to do this may allow condensation to penetrate the
vehicle.
Keep the air conditioning system's condensation
traps in the floor free of obstructions, e�g� dirt or
foliage�
Keep the internal condensation trap clean�
Cleaning
EN
15
Publicité
