Publicité
INFORMATION TO THE USERS
of one to one. The suitable separate waste collection for the following sending of the disused equip-
ment to recycling, the dealing or handling and compatible environment disposal contributes to avoid
possible negative effects on the environment and on the people's health and helps the recycling of
the materials the machine is composed of. The user's illegal disposal of the product implies the appli-
cation of administrative fines as stated in Law Decree n.22/1997" (article 50 and followings of the Law
Decree n.22/1997).
PREPARATION BY THE PURCHASER
Preparation of the installation site
The purchaser must prepare the surface on which the machine will stand suitable to support the ma-
chine weight (see the installation chapter).
Electrical requirements
The mains power installation must comply with the safely regulations and standards in force in the
country of installation and must include an efficient earth system. An omnipolar cut-off device must
be installed on the power line upstream of the machine.
The power wires must be sized according to the maximum current required by the ma-
chine to ensure a total voltage loss under full load of less than 2%.
Plumbing requirements
Prepare a suitable drain and a mains that supply water a maximum hardness of 5/6 French Degrees
(50/60 ppm).
12
Under the senses of the Directives 2015/863/EU concerning the reduction of the
use of dangerous substances in electric and electronic equipment, as well as
the disposal of wastes. The symbol of the crossed large rubbish container that
is present on the machine points out that the product at the end of its life cycle
must be collected separately from the other wastes. The user for this reason will
have to give the equipment that got to its life cycle to the suitable separate waste
collection centres of electronic and electro-technical wastes, or to give it back to
the seller or dealer when buying a new equipment of equivalent type, in terms
Publicité
