Publicité
hydraulic connections respecting the rules of hygiene and water safety to environmental protection
in force in the place of installation. So for the hydraulic plant contact an authorized technician. Always
utilise the new hose supplied for connection to the water supply. Old hoses must not be utilised.
•
On installation, the qualified electrician must fit a circuit breaker switch as foreseen by the safety
norms in force that has a contact open distance that permits the complete disconnection under
conditions of overload category III, which must be installed in the power supply system in accord-
ance with the wiring regulations. For the Australian and New Zealand markets, the disconnector
must be installed in accordance with AS/NZS 3000.
•
In case of installation in kitchens, connect the equipotential conductor to the terminal on the machine
indicated by the symbol .
•
There are some basic rules for the use of any electrical appliance. In particular:
•
Never touch the coffee machine with wet hands or feet;
•
Never use the coffee machine with bare feet;
•
Never use extension cords in areas equipped with baths or showers;
•
Never pull on the power supply cord to unplug the coffee machine;
•
Never leave the coffee machine exposed to atmospheric agents (rain, direct sunlight, etc..);
•
Never let children, unauthorized personnel or anyone who has not read this manual operate the
coffee machine.
•
The qualified electrician must also check that the section of the installation's cables is large enough
for the absorbed power of the appliance.
•
Never use adapters, multiple jacks or extension cords. When such items prove absolutely necessary,
call in a qualified electrician.
•
To prevent dangerous overheating, it is advisable to fully extend the power supply cord. Never block
the intake and/or heat dissipation grills, in particular those for the cup warmer.
•
The user must never replace the coffee machine's power supply cord. If this cord is damaged, turn
OFF the coffee machine and have it replaced by a professionally qualified technician.
•
Should it be necessary to replace the power cord, this replacement operation must only be per-
formed by an authorized service centre or by the manufacturer.
•
The coffee machine needs to be supplied with water that is suitable for human consumption and
compliant with the regulations in force in the place of installation. The installation engineer needs
confirmation from the owner / manager of the system that the water complies with the require-
10
•
It is advisable to install a mains earth leakage circuit breaker with a rated
differential current not exceeding 30mA.
•
The manufacturer cannot be held responsible for any damages incurred if
the system is not grounded. For electrical safety, this machine requires a
ground system. Contact a technically certified electrician who must check
that the line electrical capacity is adequate for the maximum capacity indi-
cated on the coffee machine label.
Publicité
