Scheppach 5904602903 Traduction Des Instructions D'origine page 28

Recommended engine oil SAE 10W-30 or 10W-40
(depending on the operating temperature).
Dispose of waste oil according to your country's reg-
ulations. It is not allowed to drain waste oil onto the
ground or mix it with other waste material.
Cleaning / replacing the air filter (fig. R)
• Unscrew the screw (m) and remove the air filter cap.
• Check the air filter cap for holes and cracks. Re-
place the damaged element.
• Wipe off dirt on the inside of the filter housing with a
clean moist cloth. Make sure that no direct enters the
opening. Set the air filter cap (n) on the filter housing
for the duration of the filter cleaning process.
• Clean the air filter at regular intervals, and replace
it if necessary.
• Remove the filter elements (n).
• Do not use abrasive cleaning agents or petrol to
clean the elements.
• Clean the filter (n) with compressed air. In cases of
stubborn dirt rinse with clear water and air-dry.
• Assemble in reverse order.
m ATTENTION!: Never run the engine without or
with a damaged air filter insert. This would allow dirt
to enter the engine, which would damage the engine.
The manufacturer warranty is then invalidated.
Cleaning / replacing the spark plug.
m ATTENTION! Only remove the spark plug when
the engine is cold!
Clean or replace spark plug as required.
• Remove the spark plug connector and clean any
dirt from the spark plug areas.
• Unscrew the spark plug and check it.
• Check the Isolator. If there is any damage, e.g.
cracks or chips, replace the spark plug.
• Clean the spark plug electrodes with a wire brush.
• Check and set the electrode gap. To make sure that
the engine remains efficient, the spark plug must
have the right electrode gap (0.7-0.8 mm).
• Manually screw the spark plug in and tighten it with
the spark plug spanner approximately 1/4 of a rev-
olution.
• Place the spark plug connector on the spark plug.
Please provide the following information in the
event of any enquiries:
• Machine data - type plate
• Engine data - type plate
Important hint in case of sending the plates to a
service station:
Due to security reasons please see to it that the vibra-
tory plates are sent back free of oil and gas!
28 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Spark plug, oil, belt, rubber pad, air filter
* Not necessarily included in the scope of delivery!
15. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.