Acoustic Signals - Mondolfo Ferro TBE160 MATIC Manuel D'utilisation

ACOUSTIC SIGNALS

In all operating modes, the display emits the acoustic signals specified in table 3:
Acoustic signal
1 short beep
2 short beeps
1 short beep +
1 long beep
3 short beeps
Slow continuous flashing
Table 3 – Acoustic signals
LUMINOUS-ACOUSTIC INDICATOR
The luminous-acoustic indicator, which is located on top of a rod next to the electrical
board, is activated by the machine each time potentially dangerous manual or automatic
commands are executed. The indicator has a flashing orange light.
The following commands activate the acoustic-luminous indicator:
Turntable opening/closing;
Turntable lifting/lowering;
Tool arm + bead breaker disc lifting/lowering;
Bead breaker disc tangency;
Tool tangency;
Side To Side.
- E - Operator's manual
nGlISH
Meaning
Confirm by pressing the
- set/cancel memory button
and
- select inches/mm button
Not used
Confirm.
The action that was taken
was successful.
Failed.
The action was not
completed successfully
or the requested action is
not permitted.
Special operating mode
active.
Action
None.
None.
None.
Repeat the action after
changing the machine
parameter being used
or perform a permitted
action.
Used in SETUP MODE (for
example for calibration)
to call attention to the
fact that a special,
potentially dangerous
operating mode is active.
91