Publicité
EN
Battery fitting and water flow settings
1
4
6
A
2
5
7
B
25
25
Quick Set-up Guide
A
3
Lift the battery using the battery handle.
Place the battery into the battery
compartment ensuring it is securely
in place and the orientation is correct
(battery handle folds down towards the
machine handle (A)).
Refit the main tank onto the machine.
Tilt the bottom of the tank towards the
handle above the battery.
Line the tank up against the machine
handle and lower the tank down. Make
sure it is securely fitted.
Clean water tank full and fitted to the
machine.
A
Located on the left and right side of the
machine are the individual water taps for
each brush.
Push the fluid control levers on the
Left and Right of the machine to set
the desired flow required, this will vary
depending on what brush / pad and floor
type the machine is being used on.
B
Note: On first use open the water taps fully
and run the machine for a short period to
purge the water flow then adjust taps to
desired flow. Make sure each lever is set
to the same position.
Publicité
