Stryker Stair-PRO 6251 Manuel D'utilisation page 20

A
B
F F i i g g u u r r e e 7 7 – – L L o o w w e e r r i i n n g g t t h h e e l l o o c c k k i i n n g g r r e e a a r r l l i i f f t t h h a a n n d d l l e e s s
A A t t t t a a c c h h i i n n g g t t h h e e h h e e a a d d s s u u p p p p o o r r t t o o p p t t i i o o n n t t o o t t h h e e u u p p p p e e r r c c o o n n t t r r o o l l h h a a n n d d l l e e
W W A A R R N N I I N N G G - - Do not use the chair with suspected cervical, spinal, or fracture injuries.
To attach the head support strap to the extendable upper control handle:
1. Wrap the loose ends of the strap around the vertical portions of the handle, then feed them through the plastic loops.
2. Pull tight and secure the strap to itself.
3. Loosen the strap to adjust the height, move the strap to the desired location, and tighten again.
S S u u p p p p o o r r t t i i n n g g t t h h e e o o c c c c u u p p a a n n t t ' ' s s h h e e a a d d w w i i t t h h t t h h e e h h e e a a d d s s u u p p p p o o r r t t o o p p t t i i o o n n
To support the occupant's head with the head support:
1. Extend the upper control handle.
2. Pull the red upper control handle release cable with one hand.
3. Pull up on the handle with your other hand.
4. Release the cable. Make sure that the handle is locked into one of the two available positions.
5. Attach the head support ( Attaching the head support option to the upper control handle (page 16)).
6. Position the head support at the base of the occupant's head to support the head.
7. For unconscious, or semiconscious occupants, secure the head with the other two parts of the strap.
8. Wrap the head support around the occupant's head. Overlap the strap ends to the desired tightness to secure.
When not in use, wrap the strap ends around the handle and attach the strap to the back of the head support.
EN 16 6252-009-005 Rev AA.0