Stryker Stair-PRO 6251 Manuel D'utilisation page 22

• Always secure the oxygen bottle to the elastic oxygen bottle holder using the red V V e e l l c c r r o o ® strap.
• Always secure the oxygen bottle in the elastic oxygen bottle holder and that the regulator valve of the oxygen bottle does
not protrude from the width of the chair.
• Always remove the oxygen bottle from the elastic oxygen bottle holder before you attempt to fold or store the chair.
1. Make sure that the chair is in the open position before you install the elastic oxygen bottle holder.
2. Place the elastic oxygen bottle holder between the two extension handle tubes under the seat.
3. Insert each of the four V V e e l l c c r r o o ® straps through the plastic buckles.
4. Pull down on the straps so they are tight before you secure the V V e e l l c c r r o o ®.
5. Pull up on the red handle and slide the D-size oxygen bottle into the elastic oxygen bottle holder.
N N o o t t e e
• Make sure that you slide the bottom end of the oxygen bottle in first.
• When you attach the elastic oxygen bottle holder, make sure that the weight capacity of the chair is visible.
6. Thread the red strap through the red handle. When the red strap is not in use, you can attach the red strap to the bottom
of the elastic oxygen bottle holder.
7. Pull the red V V e e l l c c r r o o ® strap down until tight and secure around the oxygen bottle.
EN 18 6252-009-005 Rev AA.0