Publicité
Les langues disponibles
Les langues disponibles
Features
u Slide to the back.
8.5.3 Removing the FlexBox completely
The entire FlexBox unit can be removed.
u Pull to the front.
w Side recess to support position.
Fig. 62
u Tilt and pull to the front.
8.5.4 Disassembling the FlexBox
The FlexBox can be disassembled for cleaning.
Fig. 63
u Disassemble the FlexBox.
8.6 Adjustable bottle shelf
8.6.1 Using the bottle shelf
In the bottom of the fridge section you can either use the
variable bottle shelf or the glass panel.
Fig. 64
u Remove the glass panel and store in a safe place.
u Lay bottles with their base towards the rear wall.
Note
If the bottles are protruding over the front of the bottle
shelf:
u Move the lower door rack up a place.
8.6.2 Removing the bottle shelf
You can remove the bottle shelf for cleaning.
u Remove the glass panel above the bottle shelf.
94
Fig. 65
u Lift the bottle shelf at the front and pull out.
Note
V-ZUG recommends:
Do not place any goods on the compartment lid below.
8.6.3 Inserting the bottle shelf
Fig. 66
u Slide in the bottle shelf until it engages and push down.
w The lugs at the back of the bottle shelf are connected
automatically.
w LED comes on.
8.7 Drawers
The drawers can be removed for cleaning.
The way to remove/insert the drawers varies depending on
the pull-out system. Your appliance can contain a variety of
pull-out systems.
Note
Insufficient ventilation results in an increase in energy
consumption and reduction of the refrigeration perform‐
ance.
u Leave the bottom drawer in the appliance.
u Never obstruct the vents on the interior rear wall!
Note
The energy consumption increases and the cooling power
goes down if ventilation is not sufficient.
u Always leave the fan air vents clear on the back wall!
8.7.1 Inserting the drawer
Drawer on telescopic rails
Partial pull-out fridge compartment:
* Depending on model and options
Publicité
